Shipping Industrial Machines from Atlanta to Columbus via Ground Freight

Shipping very heavy industrial machines demands Engineered crating. Use Steel‑reinforced skids with clear lifting points, hire experienced machinery movers for loading, and choose suitable heavy‑haul trailers rated for the full load. Secure and chock the machine to prevent any movement, and record its condition before pickup.

Yes, moisture‑sensitive air handling units must be Sealed against humidity. Use Shrink wrap with drying agents inside, cap all duct and cable openings, and book dry containers whenever possible. For ocean freight, ask about enhanced corrosion protection for long voyages.

Exporting heavy equipment typically calls for a Commercial invoice, packing list, Bill of lading, and any control permits applicable to your destination. Customs brokers typically recommend including serial numbers, model numbers, and precise weights for each unit, especially for backup generators. For some destinations, you should check if you need certificates of origin, fumigation or ISPM‑15 declarations for wood packaging, and safety or emissions certificates for industrial machines.

High‑value backup generators are best protected by Separate cargo insurance, as carrier liability is usually limited and may not cover full replacement cost. Insure for Full value, confirm that rigging are covered, and store inspection reports and photos in case you need to file a claim. This is especially important for custom‑built factory equipment where lead times and replacement costs are high.

Crated industrial machinery are occasionally stored outdoors short‑term if packaging is Weather‑resistant and placed on Elevated dunnage, not bare ground. However, moisture‑sensitive items like air handling units and power equipment should ideally be kept under cover or indoors. If outdoor storage is unavoidable, verify wraps and tarps regularly, maintain drainage around the site, and limit duration to reduce corrosion and electrical damage.

When shipping industrial machinery and construction equipment via ground from Atlanta to Columbus, it is essential to ensure that the equipment is properly secured to prevent movement during transit. Additionally, oversized or heavy machinery may require special permits and route planning to navigate any weight restrictions or height limitations along the route.

There are no customs requirements for transporting industrial machinery and construction equipment between Atlanta and Columbus, as both locations are within the United States. However, compliance with state and local regulations regarding transport permits, vehicle weight limits, and safety standards is necessary.

DNA reduces customs delays and risk through in-house brokerage, a digital-first customs process with automation, SAMMIE’s ability to flag potential delays before they happen, and continuous communication from your Client Success Officer.

DNA’s ETAs are AI-powered and based on real data, congestion, and vessel telemetry, whereas other forwarders often rely on static estimates copied from carrier schedules.

Clients describe SAMMIE’s data as extremely accurate and reliable, especially compared to the inaccurate or outdated data they used before adopting the platform.